DynaTrap DT1750 Manual Del Propietário

OWNER'S MANUAL
FLYING INSECT TRAP
MODEL: DTl 7S0
Thank you for purchasing the
DYNATRAP® flying insect trap!
IMPORTANT SAFETY INSTRUCTIONS
WARNING, When using electric appliances, basic precautions should always be followed, including the following:
- To disconnect, turn all controls lo the off ('O") position, then remove plug from outlet.
- Unplug from outlet when not in use and before servicing or cleaning.
- To reduce the risk of electrical shock, do not put appliance in water or other liquid.
- This appliance is provided with double insulation. Use only identical replacement parts.
- Connect only to a circuit that is protected by a ground-fault circuit-interrupter (GFCI).
See instructions for Servicing of Double-Insulated Appliances.
INSTRUCTIONS FOR DOUBLE-INSULATED, CORD-CONNECTED APPLIANCES:
In a double-insulated appliance, two systems of insulation ore provided instead of grounding. No grounding means is provided
on a double-insulated appliance, nor should a means for grounding be added to the appliance. Servicing of a double-insulated
appliance requires extreme core and knowledge of the system, and should be done only by qualified service personnel.
Replacement ports for a double-insulated appliance must be identical to those ports in the appliance.
IMPORTANT SAFETY INSTRUCTIONS
Please read these instructions before using the DYNATRAP® Insect Trap and keep for future reference.
l. Always turn unit off and disconnect plug before servicing, cleaning, or changing bulb.
2. Do not mount the unit near heat, gos, oil or other flammable materials.
3. Mount product out of reach from children.
4. Never operate this product if it hos a damaged cord or plug, ii it is not working properly, ii it hos been dropped or
damaged, or if ii hos been dropped into water.
5. This product is equipped with 2-conductor cord and 2-prong polarized plug as a safety feature. This plug will fit in a
polarized outlet only one way. If the plug does not fully lit in the outlet, then reverse the plug. If it still does not lit,
then contact a qualified electrician. To reduce the risk of electrical shock, only plug into a properly installed outlet.
Do not attempt to defeat this safety feature.
6. Do not insert fingers or any foreign objects into the unit while ii is connected to an electrical outlet.
7. Collected insects within the unit may contribute to fire, so clean insects from the unit frequent~.
8. Do not clean this product with water spray. Do not place where ii con foll into water, or near flammable materials.
9. Do not touch fan while in motion.
l 0. Do not abuse cord--never carry or hong unit by cord or yank it to disconnect from receptacle. Keep cord away from heat,
oil, or sharp edges.
11. Extension cords used with this product must be marked with suffix letters "W-A" and with a tog stating "Suitable for Use
with Outdoor Appliances".
12. Use only extension cords that hove plug and receptacles that match the product plug. Replace or repair damaged cords.
INSTALLATION & OPERATING INSTRUCTIONS
1. Unpack unit. Save carton for off-season storage (if needed).
2. If hanging the unit, place approximately 3-6 feet above the floor/ground level for optimal catch rote and easy access for
cleaning. Unit can also be placed on the floor or ground.
3. Plug into on outdoor outlet or UL listed extension cord as described in "IMPORTANT SAFETY INSTRUCTIONS."
4. Turn power switch to "ON" position. The switch is located under the upper housing on the outer rim.
5. For best catch results leave unit on of all times, except when cleaning or servicing.
6. Catch rate activity will be higher at night. For best catch results it is recommended to keep the unit away from competing light
sources. Intended for household use only.
7. It is recommended to place the unit
at
least 10 to 20 feet away from where people will be sitting.
8. This unit is all-weather resistant - designed for outdoor use including rainy conditions.
CLEANING
Frequent cleaning will prolong the life of the unit, ensure lire prevention and provide for more efficient operation.
1. Be sure to clean the unit once per week
2. Switch the unit off and unplug before cleaning
3. For weekly cleaning, twist the cage clockwise. Remove any buildup from the inside of the retaining cage.
5. When replacing the retaining cage - DO NOT press/ push against the screen windows.
REPLACING BULB
The Light bulb life expectancy is approximately 3,000 hours (or about 4 months), and should be replaced regularly to ensure
optimal UV effectiveness. Even though the bulb's light may be visible to you, its ability to attract insects diminishes over lime.
1. Turn power switch to "off" position. UNPLUG UNIT, and allow bulb to cool before replacing. Turn the unit upside down.
2. Twist the block threaded fastener piece securing the light housing counter clockwise to loosen. Move the light housing to the
side.
3. Twist the two block threaded fastener pieces securing the light and carefully remove the silver clips.
4. Cover the bulb with a cloth to protect your fingers and hand. Grasp the bulb (with your hand and lingers protected by the
cloth) and gently pull the bulb from the socket.
5. Remove any debris from the lamp socket with a brush before inserting the new bulb. Insert new replacement bulb. Place
metal clips in place and secure block threaded fasteners.
6. Twist the light housing clockwise into place and secure the block threaded fastener.
Replacement fluorescent bulbs con be found at your local retailer or con be ordered direct~ from
~ IC.
by colling
1-877-403-TRAP (8727) or visiting www.dynalrop.com
HOW THE DYNATRAP® INSECT TRAP WORKS
Flying insects ore attracted to the unit by UV light and CO2
that is generated by the photo-coto~is between the UV
lamps and special TI02 coating. The Ion then pulls the insects
into the screened base, trapping them until they dehydrate
and die. The base con be removed, allowing the contents to
be periodically emptied into the trash. The see-through screen
shows the insects trapped in the comportment, alerting you
when the net needs to be emptied.
FAN
TROUBLESHOOTING
Problem: Possible cause: Correction:
Bulb does not illuminate 1. No electrical power. 1. Che<k plug and receptacle and fuse or circuit breaker.
ond fan does not spin. 2. Che<k to make sure power is switched to the •on" position.
Bulb illuminates, but fan 1. Shorted fan. 1. UNPLUG UNIT: Examine fan to see that it is free from
does not spin. foreign material, dirt or build-up of dead inse<ts. Cleon unit as
in "CLEANING" section.
Fon spins, but bulb does 1. Bulb not seated 1. Che<k all sockets for proper bulb seating and alignment.
not illuminate. properly. 2. Replace bulb if needed following instructions under 'Replacing
2. Burnt out bulb. Bulb".
LIMITED WARRANTY
DWtUft'IC. warranties lo the original purchaser that this product is free from defective materials and
workmanship. This warranty is limited lo remedy any defective part for a period of one year from date of
original dale of purchase. Retain your original receipt as proof of purchase. This warranty does not apply
lo the light bulb, nor lo, in our judgment, misuse or abuse. If this unit has been altered, no warranty is in
force. This warranty does not apply if this unit is purchased autside the United Stales, excluding Canada
and Mexico. In no case shall ~ -be liable for any accidental, punitive, consequential, or any other
damages of any kind for breach of this or any other warranty, expressed or implied, whatsoever. Some
states do not allow limitation on how long an implied warranty lasts, so the above limitation or exclusion
may not apply lo you. This warranty gives you specific legal rights, and you may also have other rights
that vary from stale lo stale.
PARTS & ACCESSORIES AVAILABLE
PART DESCRIPTION
43050 26 Watt Replacement Fluorescent Bulb (1 piece)
Dynamic Solutions Warldwide,
LLC
12247 W. Fairview Ave. Milwaukee, WI 53226
Phone: 414-431-2819
Toll free: 1-877-403-TRAP (8727)
Toll free lox: 877-403-3293
Email: dynotropinlo@dsw-llc.com
Visit us online at www.dynotrop.com
©
Dynamic Solutions Worldwide,
LL(
SAVE THESE INSTRUCTIONS
lntertek