Handling Discs; How To Reset Your Unit - Kenwood DPX308U Guia De Inicio Rapido

Notes
• If you experience problems during
installation, consult your Kenwood dealer.
• When you purchase optional accessories,
check with your Kenwood dealer to make
sure that they work with your model and
in your area.
• Characters that conform to ISO 8859-1
can be displayed.
• The illustrations of the display and the
panel appearing in this manual are
examples used to explain more clearly
how the controls are used. Therefore,
what appears on the display in the
illustrations may differ from what appears
on the display on the actual equipment,
and some of the illustrations on the
display may be inapplicable.
About discs used with this unit
• This unit can only play the CDs with
.
• The following discs cannot be used:
- Discs that are not round
- Discs with coloring on the recording
surface or discs that are dirty
- Recordable/Rewritable disc that has
not been finalized (For the finalization
process, refer to your disc writing
software, and your disc recorder
instruction manual.)
- 8 cm (3 inch) disc (Attempt to
insert using an adapter can cause
malfunction.)

Handling discs

• Do not touch the recording surface of
the disc.
• Do not stick tape etc. on the disc, or use a
disc with tape stuck on it.
• Do not use any accessories for the disc.
• Do not use any solvents to clean discs.
Use a dry silicon or soft cloth.
• Clean from the center of the disc and
move outward.
• When removing discs from this unit, pull
them out horizontally.
• Remove the rims from the center hole
and disc edge before inserting a disc.

How to reset your unit

If the unit fails to operate properly, press
the Reset button. The unit returns to factory
settings when the Reset button is pressed.
Reset button
English | 3