Working Instructions - Grizzly BRM 46-140 BSA Q-360 InStart Traducción Del Manual De Instrucciones Original

Start the equipment on a sturdy,
level base, if possible not in long
grass. Ensure that the cutting tool
is touching neither objects nor the
ground.
Regularly check petrol and oil level
(see „Initial Operation") and refill in
due time.
Start the engine:
1. Pull the safety catch (3) towards
the handle bar and hold it.
2. Press the start button (28). The
motor starts.
Stopping the engine:
3. Release the safety loop (2). The
motor switches off and the knife
is braked.
Knife stopping device:
• Regularly examine the knife stop-
ping device:
Release the safety loop (2). The
motor switches off and the knife is
braked. The knife must stop within
7 seconds.
Wheel drive:
4. On: Pull the drive bracket (3)
towards the grip handle; the de-
vice moves forward.
Off: Release the drive bracket
(3). The device stops.

Working Instructions

Regular mowing stimulates the grass to
an increased leaf formation, but at the
same time leaves weed plants dying.
Therefore, the lawn becomes denser af-
ter each mowing process, resulting in an
evenly loadable lawn.
When mulch mowing the grass is cut in
one cycle, finely chopped and distributed
on the lawn. The cut grass acts as a natu-
ral fertiliser.
Mowing a lawn with a lateral grass ejector
is suitable for larger surfaces. The clip-
pings are ejected from the side and can
subsequently be collected manually in
one cycle.
• As far as possible, mow the lawn when
it is dry in order to protect the turf.
• Set the cutting height such that the
equipment is not overloaded.
• Run the equipment at walking speed
in lines that are as straight as pos-
sible. For uninterrupted mowing, the
lines should always overlap by a few
centimetres.
• Do not move backwards.
• On slopes, always work across the
slope.
• If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
stationary and check the equipment
for damage. Restart work only if the
equipment is undamaged.
• Switch off the equipment during long-
er breaks and for transportation and
wait until the blade is stationary.
• Clean the equipment after each use,
as described in the "cleaning and
maintenance" chapter.
GB
105