Before Use; Product Assembly - cecotec BigDry 2500 Pure LighT Manual De Instrucciones

ENGLISH

3. BEFORE USE

• Take the product out of the box and remove all packaging material.
• Make sure all parts and components are included and in good conditions. If any visible
signs of damage are observed, contact the Technical Support Service immediately.
• Always keep the dehumidifier in an upright position to avoid leakages.
• When installing the device, ensure a minimum safety distance of 30 cm to each of its
sides.
HEPA Filter installation/replacement
When the machine detects that the filter needs changing, the LED indicator for the air purifier
will continuously flash in orange.
• Pull and lift to open the filter cover (4).
• Pull out to extract the filter.
• Remove the packaging of the new filter.
• Insert the new filter into the machine.
• Clip the filter cover back into the machine. To do so, align the bottom of the filter cover
with the body of the device and push the cover towards the device.
Note: After replacing the filter, turn the appliance on and press and hold the power/purification
(11) button for seven seconds to reset it.
4. OPERATION
When the machine is connected to the power, the power indicator will turn on.
Purification button
• Press the power/purification button (11), the purification indicator will turn on and the
appliance will begin to work in air purification mode.
• Press the power/purification button (11) again and the appliance will turn off.
26 BIGDRY 2500 PURE LIGHT - BLACK
05604_BigDry 2500 Pure Light_manual_LB.indd 26 12/9/19 9:46