Descargar Imprimir esta página

CREE LIGHTING CDR Serie Instrucciones De Instalación

Luz focal led
Ocultar thumbs Ver también para CDR Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed
including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1.
DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l'alimentation avant l'installation.
2.
This luminaire must be installed in accordance with the NEC or your local
electrical code. If you are not familiar with these codes and requirements,
consult a qualified electrician.
Ce produit doit être installé conformément à NEC ou votre code
électrique local. Si vous n'êtes pas familier avec ces codes et ces
exigences, veuillez contacter un électricien qualifié.
3.
Suitable for Wet Locations.
Adspte pour les Endroits Mouiles.
4.
Use minimum 90°C supply conductors.
Les fils d'alimentation 90°C min.
5.
ACCESS ABOVE CEILING REQUIRED.
ACCES REQUIS AU-DESSUS DU PLAFOND.
6.
COVERED CEILING MOUNT ONLY.
INSTALLATION SUR PLAFOND COUVERT SEULEMENT.
7.
INHERENTLY PROTECTED. Type IC
PROTECTION INHERENTE. Type IC.
8.
8" 52W fixture is not inherently protected - Type Non IC
8" 52W PRODUIT EST NON PROTECTION INHERENTE. Type Non IC
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
Size
D1
6 in.
8-7/16 in.
8 in.
10-1/16 in.
10 in.
11-3/8 in.
TO INSTALL:
1
1 of 3
D2
H
5-7/8 in.
4-7/16 in.
7-3/8 in.
4-3/4 in.
8-11/16 in. 5-1/4 in.
2
Min.
Max.
Cutout
Cutout
6-1/8 in.
7-3/16 in.
7-9/16 in.
8-11/16 in.
8-7/8 in.
10 in.
RETROFIT INSTALLATION
STEP 1:
Make sure the POWER is TURNED OFF in which you are
installing the product;
STEP 2:
Choose CCT & lumens that you want by dip switch. See
Figure 1.
STEP 3:
If existing lamp and trim are present, remove from
ceiling or move it out of the way as it will not be needed
during installation. Measure the ceiling opening to make
sure the edge of the luminaire will cover the entire hole
and still sit firmly in the ceiling before proceeding. See
Figure 2.
CDR Series
LED Downlight
Universal Hook and Cord Mount
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION
LPN00687X0001A0_B

Publicidad

loading

Resumen de contenidos para CREE LIGHTING CDR Serie

  • Página 1 CDR Series LED Downlight Universal Hook and Cord Mount INSTALLATION INSTRUCTIONS IMPORTANT SAFEGUARDS INSTRUCTIONS D’INSTALLATION When using electrical equipment, basic safety precautions should always be followed including the following: READ AND FOLLOW ALL SAFETY INSTRUCTIONS DANGER- Risk of shock- Disconnect power before installation. DANGER –...
  • Página 2: New Construction Installation

    STEP 4: STEP 2: Choose CCT & lumens that you want by dip switch. See Figure 1. Attach the carabiner safety clip to the existing fixture housing. See Figure 3. STEP 3: STEP 5: Attach the carabiner safety clip to the existing junction box. See Figure 7.
  • Página 3: Electrical Connections

    **Connect the green or green/yellow supply ground lead to the junction box © 2019 Cree Lighting, A company of IDEAL INDUSTRIES. All rights reserved. For informational purposes only. Content is subject to change. See www.creelighting.com/warranty for warranty and specifications. Cree and the Cree logo are ®...
  • Página 4: Para Instalar

    SERIE cdR LUZ FOCAL LED Montaje universal de gancho y cordón INSTRUCCIONES DE INSTALACIÓN INSTRUCTIONS D’INSTALLATION MEDIDAS DE SEGURIDAD IMPORTANTES Al usar aparatos eléctricos, siempre deben seguirse ciertas medidas básicas de seguridad, incluidas las siguientes: LEA Y SIGA TODAS LAS INSTRUCCIONES DE SEGURIDAD PELIGRO: riesgo de descarga eléctrica.
  • Página 5 PASO 4: PASO 2: Fije el clip de seguridad de mosquetón a la carcasa de la luminaria Seleccione el circuito y los lúmenes que desea por medio del existente. Vea la figura 3. interruptor DIP. Vea la figura 1. PASO 5: PASO 3: Inserte el conducto de la lámpara en la caja de conexiones y conecte Fije el clip de seguridad de mosquetón a la caja de conexiones...
  • Página 6: Conexiones Eléctricas

    **Conecte el cable de tierra verde o verde/amarillo a la caja de conexiones © 2019 Cree Lighting, una empresa de IDEAL INDUSTRIES. Todos los derechos reservados. Para fines informativos únicamente. El contenido está sujeto a cambios. Visite www.creelighting.com/warranty para ver la garantía y las especificaciones. Cree y el ®...