Publicidad
Idiomas disponibles
Idiomas disponibles
3
6
STEP 4:
Attach the carabiner safety clip to the existing fixture housing. See
Figure 3.
STEP 5:
Insert lamp conduit into the J-box and wire to the power source per
the Electrical Connections section. See Figure 4. Reattach J-box cover
when finished
STEP 6:
Squeeze the two housing clips so they are in an upright position and
insert lamp into housing. See Figure 5.
STEP 7:
Once lamp is inside the housing, release the housing clips and continue
pushing lamp into housing until securely fixed and flush with ceiling.
See Figure 6.
STEP 8:
Restore power at the source and the installation is complete.
NEW CONSTRUCTION INSTALLATION
STEP 1:
Make sure the POWER is TURNED OFF in which you are installing the
product;
2 of 3
4
7
STEP 2:
Choose CCT & lumens that you want by dip switch. See Figure 1.
STEP 3:
Attach the carabiner safety clip to the existing junction box. See
Figure 7.
STEP 4:
Insert lamp conduit into the J-box and wire to the power source per
the Electrical Connections section. See Figure 8. Reattach J-box cover
when finished
STEP 5:
Squeeze the two housing clips so they are in an upright position and
insert lamp into opening. See Figure 9 on the next page.
STEP 6:
Once lamp is inside the opening, release the housing clips and continue
pushing lamp into opening until securely fixed and flush with ceiling.
See Figure 10 on the next page.
STEP 7:
Restore power at the source and the installation is complete.
5
8
LPN00687X0001A0_B
Publicidad
