Publicidad
Idiomas disponibles
Idiomas disponibles
9
10
ELECTRICAL CONNECTIONS
STEP 1:
Make the following Electrical Connections::
a. For 120/277/347V connect the black fixture lead to the voltage
supply or Hot 1 (for 208/240V wiring).
b. For 120/277/347V connect the white fixture lead to the neutral
supply or Hot 2 (for 208/240V wiring).
c. Connect the green or green/yellow supply ground lead to the
junction box
d. If 0/1-10V Dimming is used, connect the violet lead to the supply
positive dimming lead. If dimming is not being used ensure to cap
off the violet lead.
e. If 0/1-10V Dimming is used, connect the gray lead to the supply
negative dimming lead. If dimming is not being used ensure to
cap off the gray lead.
© 2019 Cree Lighting, A company of IDEAL INDUSTRIES. All rights reserved. For informational purposes only. Content
is subject to change. See www.creelighting.com/warranty for warranty and specifications. Cree
registered trademarks of Cree, Inc.
3 of 3
FCC NOTICE
CAUTION: Changes or modifications not expressly approved
could void your authority to use this equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved could void
your authority to use this equipment.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and
receiver.
—Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician
for help.
CAN ICES-005 (B)/NMB-005 (B)
LINE
OR HOT 1
**GREEN
NEUTRAL
OR HOT 2
VIOLET
GREY
**Connect the green or green/yellow supply ground lead to the junction box
and the Cree logo are
®
LUMINAIRE
LINE-BLACK
**GROUND-GREEN
OR
GREEN/YELLOW
NEUTRAL-WHITE
DIM (+) VIOLET
DIM (-) GREY
www.creelighting.com
LPN00687X0001A0_B
Publicidad
