Control Panel Navigation; General Setup - HQ-Power VDPL3610MHZ Manual Del Usuario

DMX-512 Connection
When applicable, connect an XLR cable to the female XLR output of a controller (not incl.) and the other
side to the male XLR input [2] of the device. Multiple devices can be linked through serial linking. The
linking cable should be a dual core, screened cable with XLR input and output connectors.
Maximum recommended serial data link distance is 500 meters (1640 ft). Maximum recommended number
of devices on a serial data link is 32 devices.
A DMX terminator is recommended for installations where the DMX cable has to run a long distance or is in
an electrically noisy environment (e.g. discos). The terminator prevents corruption of the digital control
signal by electrical noise. The DMX terminator is simply an XLR plug with a 120 Ω resistor between pins 2
and 3, which is then plugged into the XLR output socket [3] of the last device in the chain.
7. Operation
The device can be used in the following modes:
stand-alone mode: automatic or sound-activated
master/slave
with a DMX512 controller.
7.1

Control Panel Navigation

At start-up, the touch control panel shows the main menu, which consists of 6 menu options. Touch one of the
menu options to enter.
Once you enter a menu, four buttons appear at the right-hand side of the display. From top to bottom:
Button Function
[Return] to return to the main menu, or to quit a function without changing the setting
[Up] to move to the setting above, to choose the next option, or to increase a value
[Down] to move to the setting below, to choose the previous option, or to decrease a value
[Enter] to confirm and save a setting
7.2

General Setup

Display Settings
You can choose to switch the display off or use a screen saver after a period of inactivity, and to rotate the
display readout 180°.
When the screen saver is active, touch the display briefly to show the menu again.
1. In the main menu, press [Setup] and select [Screen Saver].
2. Press [Enter] and choose the desired setting:
[MODE1]: shows the DMX address
o
[MODE2]: switches the display off
o
[OFF]: keeps the display always on (no screen saver).
o
3. Press [Enter] to confirm.
4. Select [Display Reverse] and press [Enter].
5. Choose [ON] or [OFF] to toggle between normal and rotated display.
6. Press [Enter] to confirm.
Inverse Pan and Tilt Movement
You can inverse the direction of the pan and/or tilt movement:
1. In the main menu, press [Setup].
2. Select [Pan Reverse] and press [Enter].
3. Set to [ON] for pan in the inverse direction, and press [Enter]. Set to [OFF] for pan in the normal direction.
4. Select [Tilt Reverse] and press [Enter].
5. Set to [ON] for tilt in the inverse direction, and press [Enter]. Set to [OFF] for tilt in the normal direction.
Pan and Tilt Correction
If you accidentally push the device and change its pan or tilt position, you can let the device correct its position
automatically.
1. In the main menu, press [Setup].
2. Select [Code Wheel] and press [Enter].
3. Set to [ON] to let the device automatically correct the pan and tilt position.
V. 01 – 07/06/2013
VDPL3610MHZ
5 ©Velleman nv