Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
CONSTRUCT RECESS
Study the roughing-in diagrams on Page 3.
Construct a stud recess, plumb and square, in
accordance with roughing-in dimensions and framing
dimensions for the module.
NOTE: Do not install the header and right side of the
front frame until the module has been moved into place.
Nail in a 2x2 brace around the recess opening.
Cut a 5" diameter hole in the floor at the drain location.
K-12102
A
69-1/2" (176.5cm)
B
34-3/4" (88.3cm)
C
37-1/2" (95.3cm)
D
28-1/4" (71.8cm)
E
84-1/4" (214cm)
PREPARE MODULE
Install the drain according to the drain manufacturer's
instructions.
Lay out the location of holes for the supply or mixing valve.
Drill a 1/4" diameter pilot hole for the fittings at each
location marked.
A
1011312-2-
K-12103/04
65" (165.1cm)
13" (33cm)
37" (94cm)
18" (45.7cm)
84-1/4" (214cm)
2x2
Brace
E
B
D
A
NOTE: For multiple installations (if supply fittings are
located accurately during rough plumbing) make a
template of lightweight plywood that contains pilot holes to
mark hole locations on the back side of the module.
From the finished face of the module, drill holes to the
required size using a hole cutting saw.
Clean the module recess thoroughly.
4
Nail Header
With 2x2
Brace To
Framing After
Setting The
Module In
Recess
C
Fig. #4
Kohler Co., Kohler, WI U.S.A.
Publicidad
Tabla de contenido
