Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL MODULE
Carefully slide the module into the recess.
Position the right side of the front frame and header into
the recess, and nail in place.
Be sure the bottom of the module is firmly supported
against the floor. Some framing adjustments may be
necessary. However, no additional support is required.
The module must be plumb and level to ensure proper
shower enclosure installation.
Use drywall screws or #6 large-head galvanized nails to
fasten the front and top nailing-in flanges to 2x2 braces at
pre-drilled 18" (45.7cm) centers. Be careful, when nailing,
to prevent possible damage to the finished surfaces.
Complete the drain installation. Rough-in the shower,
valve, and supply connections now. Test for leaks.
Strap the supply connections to the stud supports.
Provide access for future plumbing maintenance.
INSTALL FINISH WALL MATERIAL
Install water-resistant wall material for either flush or
alcove installation as follows:
For flush installations: Install water-resistant wall
material to within 1/4" (6mm) of the module edge. Install
desired trim around the unit to conceal the module edge.
Also install trim along the bottom apron edge.
Tape, mud, and finish the wall material. Seal the openings
around the valves and outlets with plumbers putty.
For alcove installations: Install water-resistant wall
material around the unit to conceal the module edge.
Tape, mud, and finish the wall material. Seal the openings
around the valves and outlets with plumbers putty.
OTHER CONSIDERATIONS
Caulk all openings around valves and outlets with
water-resistant sealant or plumbers putty.
Install any extra grab bars or towel bars through module
walls, and fasten in place directly to bridging previously
installed. Select screws, bolts, and backing to properly
secure the grab bars. Carefully seal around the grab bar
fastener surfaces. Follow manufacturer's instructions.
Kohler Co., Kohler, WI U.S.A.
2x4 Studding
2x2 Brace
5
Fig. #5
Acrylic Module
Water-Resistant
Wall Material
Fig. #6
2x4 Studding
2x2 Brace
Module
Water-Resistant
Wall Material
Fig. #7
1011312-2-
A
Publicidad
Tabla de contenido
