Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting (cont.)
No seal was formed.
• If too many seals were made in rapid succession, unit may be too hot. Wait 2 minutes and retry.
SEAL ONLY Button is pressed but nothing happens.
• Lid isn't locked. Make sure to push Lid Lock Lever to lock Lid in place.
Part of bag was not sealed.
• Ensure that bag is aligned to left side of Vacuum Chamber.
Pump runs for an excessive length of time.
• WET VAC & SEAL requires a longer cycle than DRY VAC & SEAL. This is normal. If pump continues to run after all air appears to be removed from bag or if it runs
longer than one minute, press SEAL ONLY Button to end cycle. This may occur at very high altitudes.
Progress Bar lights flashing red.
• Flashing red lights on Progress Bar and Lid is latched. Call Customer Service.
• Function button pressed and Vacuum Sealer is not working. Let Vacuum Sealer cool 15 minutes and start again.
9
Publicidad
Tabla de contenido
