Publicidad
Step 5
Separate the EXTENSION SLIDES (2) from the
å
EXTENSION RAILS (1) as shown in the upper diagram
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (1) to the RIGHT END (A) and
å
UPRIGHT (E). Use six BLACK 1/2" FLAT HEAD SCREWS (23).
NOTE: For each EXTENSION RAIL, turn a SCREW into
å
the hole shown in the enlarged diagram. Then, slide the
inner cartridge of the EXTENSION RAIL in to fi nd the
other holes that lines up with the holes in the END and
UPRIGHT. Turn a SCREW into these holes.
NOTE: The EXTENSION SLIDES will be used later for the
å
DRAWERS.
Open end
420667
2
Push the black lever down and pull the SLIDE from the RAIL.
BLACK 1/2" PAN HEAD SCREW
(6 used in this step)
1
A
www.sauder.com
Just think. The sooner
you do this, the sooner
you do something else.
Use these holes to fasten the EXTENSION
RAIL to the END and UPRIGHT
1
23
1
E
Open end
Page 9
Publicidad
