Ecotech Italia DW 45 Manual De Uso Y Mantenimiento página 22

ENGLISH
THE MACHINE MUST BE RUN-IN! DURING THE FIRST OPERATION HOUR THE BELTS WILL SETTLE.
MAKE SURE THE STRETCHING SPRINGS WORK PROPERLY
(fig.1 n.4/n.5).
ASSEMBLING OR REPLACING THE BLADE
The blade of the cable layer consists of various parts to be assembled before proceeding
to fasten it to the machine. The assembling diagram is shown in Fig. 3.
Fig. 3 Fig. 4
On the structure of the blade must be inserted, in order: the sealing ring, the spacer and the
threaded bushing. With the bushing slightly loosened, enter the hose until it comes out from the
lower part of about 5 mm. At this point, tighten the threaded bushing using a wrench n. 17 and then
lock the hose. Complete the assembly of the left and right cable holding guides. The Fig. 4 shows
the blade correctly assembled. Now you can fasten the blade to the structure of the machine.
POSITIONING THE CABLE IN THE WINDER
Given the variety of cable types and of reel types available
on the market, the machine has been equipped with a removable
clutched cable winder. The cable can be wrapped into the cable winder (fig.1
n.10) using the lever provided on the winder. It is important
to wrap the cable clockwise so that during the work it
can be smoothly unwinded (fig. 5). If you want to use one of the
cable reels already wrapped, remove the winder by loosening
the knob (fig.6-A) and pull the retainer (fig.6-B); remove the winder
Fig.5
(fig.6-C), position the reel on the tube of the winder and use the
adapters (fig.6-D) if necessary, then fit back the retainer and tighten completely the
knob (fig.6-E).
Once the cable has been positioned in the winder, enter the cable end in the tube
of the blade (fig. 7-A) until it comes out from the bottom a few centimetres (Fig. 7-B).
7