Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Commissioning
Charge the battery
replaced.
„ Check the device and the charger before each use.
If either has been dropped or otherwise subject
to impact, be sure to check for any damage and
replace damaged parts immediately.
„ Take any foreign bodies out of the working area
before use.
„ Wear suitable work clothing:
Protective goggles
Long trousers
Robust, non-slip footwear
„ Ensure that you have a sound footing when working.
„ Keep other persons away from dangerous areas.
„ Keep body, body parts and clothing away from
the cutter area.
„ Only work when there is adequate daylight or
„ Move the device away from the body when working.
„ Only remove cuttings when the motor is at
a standstill.
„ Never leave the device unattended when it is ready
for operation.
Check, after contact with foreign bodies, for dam-
age to the rechargeable grass and shrub cutter.
In the event of of serious damage, take the device
to a AL-KO service centre.
The charging device becomes warm when
charging. Do not operate the device on an easily
„ The device handle can become warm during the
charging process. This is normal.
„ The battery in the device is partially charged! Fully
„ Do not use the device when charging.
14
„
„
„
artificial lighting.
Danger - risk of fire and explosion!
flammable ground or in a flammable environment.
charge the battery before using it for the first time.
Operation
Turn on the device
Turn off the device
Changing the blade
The battery can be charged in any state
of charge. Interrupting the charging process
does not adversely affect the battery.
1. Connect the charger using the charging point on
the rechargeable grass and shrub cutter. (
2. Connect the charger to the mains supply.
The charging process starts when the green LED
remains constantly illuminated. The battery is fully
charged once the LED is no longer illuminated.
(
1)
The temperature range for the charging process
should between 0 °C and +45 °C.
Maximum charging time: 4 h
3. Disconnect the plug from the charging device and
from the device.
The battery is protected from overcharging and
can thus remain connected to the mains supply.
1. Push the die kill-switch forwards. (
2. Press the activating switch. (
3. You can release the kill switch whilst you press
the switch.
A clicking sound can be heard after you have
turned the device on. This is due to the mechanics
and fully normal.
1. Release the activation switch.
2. Wait until the blade stops moving. The blade contin-
ues to run after the motor has been switched off!
Danger - risk of injury!
The blades continue to run after the motor has
been switched off!
Translation of original user instructions
1)
2-1)
2-2)
GS 3,7 Li Multi Cutter
Publicidad
