Waste Disposal; Troubleshooting - IMER COMBI 250 VA Manual De Uso

Ocultar thumbs Ver también para COMBI 250 VA:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Ensure that the contacts of the power plug and plug-switch assembly
are effi cient. If oxidation is detected, clean immediately
- In the event of activation of the RCCB, check the machine
and arrange for repairs if necessary exclusively by specialised
personnel.

12.7 Waste disposal

As regards disposal of processing waste observe all current legislation
in the country of use.
13. RESIDUAL RISKS AND SAFETY SIGNS
Although the sawing machine has been manufactured fully in complian-
ce with current regulations, residual risks exist that cannot be eliminated
and involve the use of appropriate individual protection devices. Ade-
quate warning signs fi tted on the machine point out both the risks and
the behaviour to be followed.
NOISE RISK
Ear protection must be worn
RISK OF INJURY TO THE HANDS
Safety gloves must be worn
RISK OF INJURY TO THE EYES
Eye protection must be worn
ABNORMAL USE RISK
Reading the manual before use is compulsory
Cutting with water is compulsory
DANGER OF CUTTING
DANGER OF ELECTROCUTION
DANGER OF LASER BEAM
Please be reminded that checking the use of IPDs is delegated to the
employer.
IMER INTERNATIONAL S.p.A.
COMBI 250/1000 VA

14. TROUBLESHOOTING

- CAUTION!!! All maintenance operations must be performed
exclusively with the machine switched off, with the selector set to
"0" and the power plug disconnected from the mains.
The motor does not
start when the start
switch is pressed
Cooling water fails
to reach the blade
The blade does
not cut
* Operation to be carried out by an electrician
15
Trouble
Causes
Current does not reach
the supply line
The socket and plug
are not connected
properly
The differential switch
is off
The power cable from
the plug to the panel
is cut off
An electric wire inside
the motor terminal strip
is cut off
An electric wire inside
the panel is cut off
The start switch is
faulty
Low water level in tank Restore the water level
Pump fi lter clogged
Current fails to reach
the pump
Pump failure
Blade fi tted in the
opposite direction to
that of rotation
Worn blade
GB
Remedies
Check the line *
Restore correct
connection
Turn the differential
switch on
Change the cable *
Restore the connection *
Change the switch *
Change the switch *
Clean the pump fi lter
Check the pump
electrical supply *
Change the pump *
Remove the blade
and reposition it in the
direction shown on the
blade label
Change the blade

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Combi 1000 va118817011881721188173

Tabla de contenido