Special Setup Mode - Ecler CA200z Manual De Instrucciones

4.2. Special setup mode

The CA200z's special SETUP mode can be accessed by pressing and holding the front
rotary encoder knob. This mode is for adjusting the unit's operating mode (STEREO, MONO,
BRIDGE or ZONES), setting the LCD screen contrast, recovering presets (configuration memories),
etc.:
12
SETUP MODE
To enter SETUP MODE press and hold the front knob for more than 2.5 seconds
Front knob SP: Short Press (press the front panel knob briefly, less than 0.5 seconds)
Front knob LP: Long Press (press & hold the front panel knob for more than 2.5 seconds)
DEFAULT MODE (MASTER volume control and ZONE selection)
SP to
select
SP
ZA or
MASTER VOLUME
ZB
SWITCH ZA / ZB
/ ZONE SELECT
(only for ZONES mode)
SETUP MODE
SP
LOAD PRESET
1 ... 5
Rotate knob
to browse
options
OUTPUT MODE
Rotate knob
to browse
options
Rotate knob
to browse
LCD MODE
options
Rotate knob
to browse
options
LCD CONTRAST
Rotate knob
to browse
options
VERSION INFO
vX.Y
Rotate knob
to browse
options
ADVANCED MODE
KEY CODE REQUIRED
Rotate knob
to adjust
Level
main
shown in
output
LCD
volume
graphbar
OUTPUT LEVEL
Level: 0 to 64 (64 steps)
LP to enter
LP
the SETUP
mode
PRESET
number
shown in
LP to enter
the PRESET
LP
recovery
mode
LOAD PRESET
1, 2, 3, 4 or 5
SP to load
PRESET
SP
and get
back
Mode
shown in
LP to enter
the OUTPUT
LP
mode
selection
OUTPUT MODE
STEREO
MONO
SP to get
BRIDGE
SP
back ZONES
shown in
LP to enter
the LCD
LP
working
MODE
LCD MODE
ON
DIMMED
SP to get
OFF
SP
back
Contrast
level shown
LP to enter
the LCD
LP
CONTRAST
adjust mode
LCD CONTRAST
Level: 0 to 100
SP to get
SP
back
Firmware
version
shown in
LCD
MIC1 MIC2
Press and hold MIC1 + MIC2 +
LP
+ + front panel knob to enter the
MIC SETUP ADVANCED MODE
Rotate knob
to select
PRESET
number
LCD
Rotate knob
to select a
mode
LCD
Rotate knob
Mode
to select a
mode
LCD
Rotate knob
to adjust
level
in LCD