Ecler CA200z Manual De Instrucciones página 15

Note: In ZONES mode, the detailed LINE input adjustments are made independently for the
selected zone, A or B: a single LINE audio source can be adjusted with different volume and tone
controls for zones A or B. In STEREO, MONO and BRIDGE (single zone) modes, the detailed
adjustments are shared, given that there are no zones for independently directing and adjusting
the audio sources. During detailed adjustments of a LINE input, the affected zone is displayed in
the top left corner of the LCD screen (ZA or ZB).
To enter the LINE SETUP MODE, first select zone A or B with a tap of the front knob
or the IR remote (only when using the ZONES mode), then press LINE1 or LINE2 or
Front knob SP: Short Press (press the front panel knob briefly, less than 0.5 seconds)
Front knob LP: Long Press (press & hold the front panel knob for more than 2.5 seconds)
Default mode (STEREO / MONO / BRIDGE / ZONE A or ZONE B)
LINEx setup mode
(x = 1, 2, 3 or 4)
Rotate knob
to browse
options
Pressing and holding down one of the MIC keys accesses its detailed adjustments. The
complete process for entering and operating in this special adjustment mode, as well as the available
adjustment options, are shown in the following graphic:
Note: It is possible to exit the special adjustment mode (returning to the default mode) at any time
by briefly pressing any front panel key or waiting 20 seconds without working the controls.
Note: In ZONES mode, the detailed VOL adjustment of the MIC inputs are made independently
for the selected zone, A or B, and a single MIC audio source can be adjusted with different
volumes for zones A and B (but with the same BASS/TREBLE adjustments for both destination
Front panel LINE sources setup
LINE3 or LINE 4 key and hold it for more than 2.5 seconds
LINE1, 2, 3 or 4
SP
VOL
Rotate knob
to browse
options
BASS
Rotate knob
to browse
options
TREBLE
Press & hold LINEx key
to enter LINEx setup mode
LP to enter
LP
the VOLUME
adjust mode
LINEx VOLUME
SP to get
SP
back
LP to enter
LP
the BASS
adjust mode
SP to get
SP
back
LP to enter
LP
the TREBLE
adjust mode
SP to get
SP
back
Rotate knob
Level
to adjust
shown in
level
LCD
Level: 0 to 64
Rotate knob
Level
to adjust
shown in
level
LCD
LINEx BASS
Level: -10 to +10
Rotate knob
Level
to adjust
shown in
level
LCD
LINEx TREBLE
Level: -10 to +10
15