Spezieller Konfigurationsmodus (Setup); Setup Mode - Ecler CA200z Manual De Instrucciones

MIC-Eingänge, zugänglich über langes Drücken der entsprechenden Tasten am vorderen
Bedienfeld.

4.2. Spezieller Konfigurationsmodus (SETUP)

Durch langes Drücken des vorderen Drehreglers gelangt man in den speziellen
Konfigurationsmodus oder SETUP des CA200z. In diesem Modus werden die Einstellungen der
Arbeitsweise des Geräts vorgenommen (STEREO, MONO, BRIDGE oder ZONES), der Kontrast des
LCD-Bildschirms, das Aufrufen der Presets (Konfigurationsspeicher) usw.:
Front knob SP: Short Press (press the front panel knob briefly, less than 0.5 seconds)
Front knob LP: Long Press (press & hold the front panel knob for more than 2.5 seconds)
DEFAULT MODE (MASTER volume control and ZONE selection)
SWITCH ZA / ZB
(only for ZONES mode)

SETUP MODE

78
SETUP MODE
To enter SETUP MODE press and hold the front knob for more than 2.5 seconds
SP to
select
SP
ZA or
MASTER VOLUME
ZB
/ ZONE SELECT
SP
LOAD PRESET
1 ... 5
Rotate knob
to browse
options
OUTPUT MODE
Rotate knob
to browse
options
Rotate knob
to browse
LCD MODE
options
Rotate knob
to browse
options
LCD CONTRAST
Rotate knob
to browse
options
VERSION INFO
vX.Y
Rotate knob
to browse
options
ADVANCED MODE
KEY CODE REQUIRED
Rotate knob
to adjust
Level
main
shown in
output
LCD
volume
graphbar
OUTPUT LEVEL
Level: 0 to 64 (64 steps)
LP to enter
LP
the SETUP
mode
PRESET
number
shown in
LP to enter
LCD
the PRESET
LP
recovery
mode
LOAD PRESET
1, 2, 3, 4 or 5
SP to load
PRESET
SP
and get
back
Mode
shown in
LP to enter
LCD
the OUTPUT
LP
mode
selection
OUTPUT MODE
STEREO
MONO
SP to get BRIDGE
SP
back ZONES
shown in
LP to enter
the LCD
LP
working
MODE
LCD MODE
ON
DIMMED
SP to get
OFF
SP
back
Contrast
level shown
LP to enter
in LCD
the LCD
LP
CONTRAST
adjust mode
LCD CONTRAST
Level: 0 to 100
SP to get
SP
back
Firmware
version
shown in
LCD
MIC1 MIC2
Press and hold MIC1 + MIC2 +
LP
+ + front panel knob to enter the
MIC SETUP ADVANCED MODE
Rotate knob
to select
PRESET
number
Rotate knob
to select a
mode
Rotate knob
Mode
to select a
mode
LCD
Rotate knob
to adjust
level