Before Using The Equipment; Area Of Use - SPIT 445 Instrucciones De Empleo Y Mantenimiento

Instructions for use
Before using the
equipment

Area of use

Tools
Inserting of the
chisel
Removal of the
chisel
Consider the main voltage: The voltage of the source of supply is
the same that shown on the information plate on the equipment.
This tool is solely determined for chiselling mainly mineral materials
(e. g. concrete, masonry, limestone, ...). Improper use may cause
injury or damage the tool.
It is important to clean and, if necessary, slightly grease the tool shaft
before inserting into the tool holder of the machine.
The tried and tested 3-groove profile allows the chisel blades to be
used in three positions 120° apart, as working conditions require.
First make sure that the shaft of the tool is clean. Next, with a slight
twisting motion, put the shaft of the tool into the chuck.
The tool locking device (B) automatically returns to its original posi-
tion if the tool has been inserted properly.
Attention! Check locking – it should not be possible to pull out the
chisel (risk of injury!).
To remove the tool, push back tool locking device (B) against slight
pressure up to first stop. Now tool can be removed.
Warning! Chisels become hot during use. For this reason, never
touch the chisel with your bare hands (risk of injury!).
7