Operation; Start-Up; Assembling The Mt Tumbler 500/500 Med - Master MT Tumbler 500 Manual De Uso Y Mantenimiento

Transporte
Box 80 x 106 x 114 cm = 160 kg // MT Tumbler 500/500 MED net weight = 95 kg
Conexión eléctrica
Placement
The MT Tumbler 500/500 MED must be placed on a flat surface without irregularities on the ground. The machines are only
suitable for indoor use and under no circumstances should be exposed to moisture or water. When you need an increase in
productive performance and optimum processing of the flowers, a tandem of two machines can be set up with the help of
the MT Tumbler 500 Rail, which can control the degree of tilting of the machines.

Operation

The MT Tumbler 500/500 MED enable you to work with fresh and dry flowers. To process dry flowers, a specific drum is
required. Ask the commercial department of Master Products if you want to trim dried raw material
The MT Tumbler 500/500 MED are distributed with a cut-off mechanism that must not be tampered with by the consu-
mer. If the grids and/or blades are changed and/or cleaned, it is essential to comply with the safety regulations mentioned
in this manual.

Start-up

Assembling the MT Tumbler 500/500 MED

dentify hopper (B), the two short handles (C), the two long handles (D), the four ISO 7380 M8x25 screws (J) and
1
the four DIN 125 M8 washers (I). ( I, J ).
Place the longest handles (D) at the input of the machine and the shortest (C) at the output.
2
Release the machine from the base of the pallet using a Phillips screwdriver to loosen the fasteners at each
3
end.
Read and understand this use and maintenance manual before using the machine.
4
Remove the machine from the pallet by holding it by the imput (D) and output (C) handles with the help of
5
another person.
Fit the inlet hopper (B). Secure it near with the barrel leaving a small gap to avoid friction during machine ope-
6
ration. Finally, secure the hopper (B) with the fasteners (E).
View the technical support video for the unpacking and assembly
process using this QR code or look for the video on our YouTube channel
"Unpack and assemble MT Tumbler 500"
230 V 50/60 Hz single phase power supply.
18