Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the
shaver has to be fully discharged (by shaving) every 6 months approximately.
Then recharge the shaver to full capacity.
Environmental notice
Product contains batteries and/or recyclable electric waste. For
environment protection do not dispose of in household waste, but
for recycling take to electric waste collection points provided in your
country.
Clean&Renew
Braun Clean&Renew has been developed for cleaning, charging and storing
your shaver. Clean your shaver daily in the Clean&Renew.
During the automated cleaning process, the shaver is switched on and off
at intervals to obtain best cleaning results. Since the specially formulated
cleaning fluid contains a small amount of oil, the cleaning procedure also
fulfils the lubrication needs of the shaver.
Description
1
Start/release button
2
Contact bow
3
Lift button for cartridge exchange
4
Level indicator
5
Cleaning cartridge
Before using Clean&Renew
Installing the cartridge
• Press the lift button (3) to open the housing.
• Hold the cartridge down on a flat, stable surface (e.g. table). Carefully
remove the lid from the cartridge. Slide the cartridge into the base as far
as it will go.
• Slowly close the housing by pushing it down until it locks.
Replacing the cartridge
After having pressed the lift button to open the housing, wait for a few
seconds before removing the used cartridge. Before discarding the used
cartridge, make sure to close the openings using the lid of the new cartridge,
18
(C)