Environmental Notice - Braun 3 Serie Manual Del Usuario

Alternatively, you may clean the shaver using
the brush provided:
• Switch off the shaver. Remove the shaver
foil.
• Using the brush, clean the cutter block and
the inner area of the shaver head. However,
do not clean the shaver foil with the brush as
this may damage the foil.
• Put a drop of light machine oil onto the long
hair trimmer and the shaver foil.
Replacement light for shaving parts / Reset
To maintain 100% shaving performance,
replace your foil and cutter block, when the
replacement light for shaving parts (8) comes on
(after about 18 months) or when worn.
Change both parts at the same time for a closer
shave with less skin irritation.
(Shaver foil and cutter block: 31S)
The replacement light will remind you during the
next 7 shaves to replace the shaving parts. Then
the shaver will automatically reset the display.
After you have replaced the shaving parts (foil
and cutter block), use a ball-pen to push the
reset button (9) for at least 3 seconds to reset
the counter.
While doing so, the replacement light blinks
and goes off when the reset is complete.
The manual reset can be done at any time.
Preserving the batteries
In order to maintain the optimum capacity of the
rechargeable batteries, the shaver has to be
fully discharged (by shaving) every 6 months
approximately. Then recharge the shaver to
full capacity. Do not expose the shaver to
temperatures higher than 122 °F/50 °C for
extended periods of time.

Environmental notice

This appliance contains rechargeable
batteries. To protect the environment,
do not dispose of the appliance in the
household waste at the end of its useful life.
Disposal can take place at a Braun Service
Center or appropriate collection sites.
Caution: Opening the housing will destroy the
appliance and invalidate the guarantee.
Subject to change without notice.
For electric specifications, see printing on the
special cord set.
7