Filter Removal - Morphy Richards 43690 Manual De Instrucciones

B
Â
4
¤
⁄
‹
‰
‚
fi
‡
Features
A
⁄ Lid
¤ Lid knob
‹ Spout filter
› Concealed element
fi 360°connector
fl Cordless base unit
‡ Cord storage
· On/off switch
‚ Power on neon
„ Water level indicator
‰ Concealed element (inside)
 Whistle on/off switch
Using
Filling the kettle
1 Wherever possible fill through the
spout, as this helps to free the filter
from limescale build-up.
• The integrated water level indicator
allows you to easily see the amount
of water in the kettle.
• Always ensure that the level of
water in the kettle is filled to at least
the minimum level shown on the
•
2
•
„
›
·
3
4
fl
5
•
6
•
•
1
2
3
water gauge. Should your kettle not
have a water gauge, always ensure
that the element is covered.
Boil only as much water as you
need as this saves electricity.
Place the kettle on the base unit,
ensuring the kettle locates on to the
360° connector.
The 360° connector allows the
kettle to be located at any position.
- ideal for left and right handed
users and for convenient positioning
on the worktop.
Plug in and switch on at the wall
socket.
Switch the kettle on. The 'power on'
neon will light up.
When the water boils the kettle will
switch off automatically.
If you are using the kettle for the
first time, pour away the boiled
water and refill.
Lift the kettle from the base unit by
the handle ensuring you hold the
kettle level.
To re-boil, switch to ON again. If the
kettle has just switched off wait a
minute or so before switching it
back on again.
If you do not put in enough water, or
switch on the kettle when it is
empty, the safety cut-out will switch
off the power automatically. If this
happens, refill and wait a few
minutes for the element to cool,
then use as normal.

Filter removal

Open the lid.
Lift the filter upwards from its
holder.
To refit the filter, slide it into the side
wall guides of the filter holder until it
clicks into place.
WARNING: Unless the filter is
fitted correctly, the kettle lid
may not close and lock
securely.