At The End Of The Work; Maintenance - Fimap FB45 Manual De Uso Y Mantenimiento

The appliance has three operating speeds; to select one of these
speeds turn the switch (5) clockwise (Fig.6).
5
6
The appliance is equipped with an operating timer; to select the
operating time, simply turn the knob (6) clockwise (Fig.7). As soon
as the knob is released on the chosen time, the operating timer will
start, and will stop when it arrives to position "0".
6
7
If the air has to be blown under a carpet, proceed as follows:
1. Turn the knobs (7) anti-clockwise (Fig.8).
2. Insert the carpet beneath the blade (8) (Fig.9).
7
8
8
At the end of the work, and before carrying out any type of
maintenance, perform the following operations:
1. Take all necessary steps to ensure that the device is in a safe
condition (read the section "MACHINE
2. Take the appliance to the designated storage area.
At the end of the work proceed as follows:
1. Take all necessary steps to ensure that the device is in a safe
condition (read the section "MACHINE
2. Take the device to the dedicated maintenance area.
3. With the aid of a vacuum cleaner, remove impurities present in
the air inlet nozzles (1) (Fig.1).
1
1
7
9

AT THE END OF THE WORK

SAFETY").

MAINTENANCE

SAFETY").
2
2
ATTENTION: By positioning the knob to ON, the timing
function is not in operation.
ATTENTION: It can be set from a minimum of 30 minutes up
to a maximum of 180 minutes.
3. Fasten the carpet to the appliance by turning the knobs (7)
clockwise.
ATTENTION: Park the appliance in an enclosed place, on a
flat surface; near the appliance there must be no objects that
could either damage it, or be damaged through contact with it.
4. With the aid of a vacuum cleaner, remove impurities present in
the air inlet nozzles (2) (Fig.2).
5. With the aid of a damp cloth, clean the outside surfaces of the
appliance (Fig.3).
3
20