Foster EcoPro G2 Instrucciones De Funcionamiento Originales página 2

GB
Important Note to the Installer:
If you are not the user please pass this document on to them as it contains
important guidelines on operation, loading, cleaning and general
maintenance and should be kept for reference.
General Electrical Safety
Foster Refrigerator recommends that the equipment is electrically connected via a Residual Current
Device; such as a Residual Current Circuit Breaker (RCCB) type socket, or through a Residual Current
Circuit Breaker with Overload Protection (RCBO) supplied circuit.
Disposal Requirements
If not disposed of properly all refrigerators have components that can be harmful to the environment. All old
refrigerators must be disposed of by appropriately registered and licensed waste contractors, and in
accordance with national laws and regulations.
Start-Up and Operation
After unpacking, clean and allow the cabinet to stand for 2 hours before turning on (cleaning
directions supplied within this manual). Ensure the cabinet is situated where neither hot nor cold air
sources will affect its performance. Make sure that a minimum clearance of 310mm above and 50mm
around the cabinet is available for ventilation and effective operation.
Connect the unit to a suitable mains power outlet and turn the supply on. Please do not plug or unplug the
unit with wet hands.
The cabinet will energise briefly showing
display. The unit is now in standby.
Standby
Pressing this switch for 3 seconds will turn the unit on (the switch backlight is static and the display shows
the operating temperature) or into standby (the switch backlight pulses slowly on & off).
As the operating temperature has been pre-set no adjustments are required. Allow the cabinet to reach its
normal/set operating temperature before loading.
Display Icons and Switches
Keypad Lock
Service Mode
Compressor Function
Evaporator Fan Function
Data Download Switch
Power Switch
Decrease Switch
(Some icons or switches are only visible during adjustment, when activated by parameters or through
--
followed by the power switch slowly pulsing with a blank
operation/manual selection).
Warning/ Alarm
Temperature Setting
Defrost Function
Reduced Energy Mode
Light Switch
Increase Switch