Foster EcoPro G2 Instrucciones De Funcionamiento Originales página 3

GB
User Adjustment Mode
You are required to enter this mode to make any setup changes.
These include Set Point, Keypad Security, and display of T1, 2 or 3 probe temperatures.
Press and immediately release
Press to scroll through the following screens:
Adjustment
Screen
To exit this mode scroll back to the adjustment screen and press
will revert to the normal display showing the operating temperature.
Set Point and Other Mode Adjustments
Access the adjustment mode as described above. Using the
requires adjustment i.e. 'Set Point' this is the minimum temperature the cabinet is allowed to cool down to
(the display shows the temperature and flash/pulsing
To adjust this press and release
switch. Confirm the change by pressing and releasing
Scroll through the modes with the
release to exit and save.
If at any point the display is left for 30 seconds it will revert to the normal display and no changes
will be saved.
Keypad Security Settings
Access the 'Keypad Security' screen as described above.
The screen will show the current status, initially pre-set to '
and will show constantly. (If you modify this setting with
will show constantly and the cabinet will not be able to be put into standby, carry out a manual defrost,
adjust temperature set point, download data or switch on/off the units lights. To confirm any change you
again so the next screen '
must press
Exit any of the 'Adjustment Modes' as described above.
Internal Light (where fitted)
To switch on the lights press and release
press and release and the switch backlight will flash/pulse.
, after which the
Set
Keypad
Point
Security
Screen
Screen
the icon will show constantly. Adjust the setting with the
or switch until you return to the adjustment screen and press and
' shows).
so that the switch backlight is on continuously. To switch off
and switches will flash/pulse together.
T1 T2 Probe
Probe
Temperature
Temperature
Only visible when fitted
or wait for 30 seconds and the display
or switches to scroll to the mode that
icon).
again, the next mode will automatically show.
', with
flashing. Press and release
to show ' ' the keypad will be locked,
T3 Probe
Temperature
or