Inserting Or Changing Batteries - Steinbach Digitales Funk Pool Manual De Instrucciones

The indoor unit can be hung on a wall using the wall mount
16
The signal range between outdoor unit and indoor unit is up to 60 m (65 yds.)
in an unobstructed environment. Reinforced concrete structures or similar
obstructions reduce the signal range. Likewise, positioning the outdoor unit
close to sources of electrical interference (e.g. computer monitors, TV sets,
radio equipment) should be avoided.
Correct temperature measurement takes place in the shade.
Protect the measuring devices from direct sunlight to avoid
false measurement results.
Water or other liquids may cause the batteries
to short-circuit in the battery compartment.
- Make sure that neither water nor other liquids enter the battery
compartment.

Inserting or changing batteries

Outdoor unit
Change the batteries of the outdoor unit
appears on the display.
1. Remove the screw
2. Open the housing by turning the locking ring
3. Remove the locking ring
and the display screen
The housing is open.
4. Pull the battery holder
5. Remove the old batteries.
At delivery there are no batteries in the battery compartment.
6. Insert 2 new AAA batteries.
Always exchange all batteries. Never mix batteries with different charge
levels. Use only batteries that are listed in the "Technical Data" section.
7. Push the battery holder
26
or it can be set up using the support stand
NOTICE!
to undo the locking device (see Fig. C).
19
together with the transparent display cover
11
.
14
out of the housing (see Fig. D).
20
all the way into the housing.
20
as soon as the battery symbol
12
counter-clockwise.
11
.
18