8. Place the display screen
protrudes into the recess
9. Place the transparent display cover onto the display screen
fits snugly against the sealing ring.
10. Place the locking ring
11. Screw the locking ring
12. Screw the screw
The display elements of the display appear briefly. The measured outdoor
temperature is displayed next to the outdoor temperature symbol
channel is displayed by the channel display
Indoor unit
Change the batteries of the indoor unit
appears on the display.
1. Remove the battery compartment cover from the battery compartment
.
17
2. Remove the old batteries.
At delivery there are no batteries in the battery compartment.
3. Insert 2 new AAA batteries.
Always exchange all batteries. Never mix batteries with different charge
levels. Use only batteries that are listed in the "Technical Data" section.
4. Close the battery compartment
The display elements of the display appear briefly. The measured indoor
temperature is displayed next to the indoor temperature symbol
signal symbol
8
for the signal from the outdoor unit
the signal from the outdoor unit, the temperature measured by the outdoor
unit
is displayed.
12
Manual transmitter search
Occasionally the indoor unit
unit
(e.g., after a signal failure or after changing the batteries). If the
12
indoor unit is not receiving the signal from the outdoor unit, 3 horizontal
lines ("--.-") are displayed next to the outdoor temperature symbol
of the measured temperature. In order to restore the wireless connection, it
might be necessary to initiate the transmitter search manually.
onto the housing so that the locking pin
14
22
onto the display cover.
11
clockwise onto the housing.
11
into the tab
19
blinks for about 3 minutes while the indoor unit
loses the wireless signal from the outdoor
1
(see Fig. D).
(see Fig. C).
15
.
7
as soon as the battery symbol
1
with the battery compartment cover.
17
. As soon as the indoor unit receives
12
21
so that it
14
. The set
9
. The
10
searches
1
instead
9
27