Machine Information - Ferm TSM1036 Manual Del Usuario

Warning! Do not use HSS blades.
• Insert the push stick in its holder when not in
use.
• Use a push stick or a push block to guide the
workpiece.
Warning! Do not use the saw for rebating
or grooving.
• Only use saw blades, whose maximum speed
is at least the speed indicated on the saw and is
suitable for the material to be cut.
• During the transport, the upper part of the saw
blade has to be covered, by the guard.
Switch off the machine immediately when you
discover:
• A defective mains plug or mains lead.
• A defective switch.
• Overheating of the machine.
• Smoke or odeur caused by scorched insulation.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in the
wall outlet.
Using extension cables
• As a supply for this machine always use an
unloaded line and/or an extension cable with
conductors of at least 1,5 mm
with a 16 A fuse. Be sure that this extension
cable is not longer than 20 metres.
• This machine can be switched to the single-
phase network (230-240 V/50 Hz). If you are
in doubt about the earth of the electricity
provisions, consult an electrician first.
8

2. MACHINE INFORMATION

Intended use
This power tool is intended as a stationary
machine for making straight lengthways and
crossways cuts in hard and soft wood free from
foreign bodies such as nails, screws and mortar.
Technical specifications
Model No.
Voltage
Frequency
Power input
No load speed
Bevel angles
Sawblade dimensions
Number of teeth
Max. workpiece height 90º
Max. workpiece height 45º
Thickness of the riving knife
Blade body thickness
Weight
Lpa (sound pressure level)
Lwa (sound power level)
Vibration value
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 60745; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- using the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level.
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
DESCRIPTION
2 and protected
The numbers in the text refer to the diagrams on
page 2-6.
1. Table surface
2. Blade guard
3. Push stick
TSM1036
230-240V~
50 Hz
800W
2950/min
0° <> +45°
Ø 200×2,4 × Ø 16mm
24T
43 mm
27 mm
2.2 mm
1.8 mm
13 kg
99.6 +3 dB(A)
112.6 +3 dB(A)
<2.5 m/s 2