EN
¾ Store the power pack and charger separately.
Risk of injuries or material damage.
¾ Pull out the mains plug.
¾ Do not open the device.
¾ In case of doubt always consult a specialist workshop.
Fault
The charger swit-
ches off.
Does not charge
(steady red light).
Fault
(red flashing light).
Servicing / Care
WARNING !
Risk of injuries or material
damage.
¾ Before any work on the
device, switch off and
remove the power pack.
¾ Pull out the mains plug.
¾ Do not open the device.
¾ Servicing and repair must
only be performed by a
specialist.
Keep the charger clean and dry.
Î
12
Troubleshooting information
Possible cause
The power pack is too hot.
The power pack is defective.
The contacts are dirty.
The power pack is not correctly
inserted.
The fuse at the mains connection
has blown/is defective.
The battery temperature is outside
the range 5 °C - 45 °C.
The power pack is defective.
Note
WARNING !
Remedy
Allow the power pack to cool.
Replace the power pack.
Clean the contacts.
Insert the power pack correctly
in the charger.
Contact an electrician to arrange
its repair.
Allow the power pack to cool or
heat up.
Replace the power pack.
Clean the contacts and ventilation slits
Î
of the charger pack with a soft dry cloth
or if it is heavily soiled use a brush.
CE Declaration of Conformity
Further details about the device
are contained on the separately
enclosed CE Declaration of
Conformity. This forms a part of
this instruction manual.
Troubleshooting information
ABC 36-03