Beta 3070BE/K Instrucciones página 25

INSTRUCTIONS FOR USE
EN
EXAMPLE
MEASUREMENT RESULT
Move the wheel manually until all the LEDs corresponding to the side being inspected light up.
The display shows the measured unbalance, and thus indicates the weight to apply to the point shown by the
arrow in the drawing below
Pressing the keys allows the positions of the weights to be selected. For each position, the display
will show the value of the weight to apply.
For unbalance within tolerance 0 (zero) is displayed; allows the values within tolerance to be viewed.
SPLIT FUNCTION (hidden adhesive weight)
The SPLIT function is used to place the adhesive weights behind the wheel spokes, so that they are no longer
visible (for alloy rims).
NB: This function is applicable to spokes whose angles range between 18° and 120°; for angles outside this
range, errors 24, 25 or 26 will occur (for a detail description of errors, see section "DIAGNOSTICS"). Spokes
with irregular or inconsistent angles can be compensated.
Use this function in the mode if an adhesive weight is expected to be applied inside the rim.
Enter the wheel dimensions and turn the wheel manually.
1. Turn the wheel to the outer side unbalance correction position.
25