Black+Decker BXEFD40E Traducción De Instrucciones Originales página 5

Use and care:
♦ Fully unroll the appliance's power cable before each use.
♦ Do not use the appliance if the on/off switch does not
work.
♦ Use the appliance handle/s, to catch it or move it.
♦ Do not use the appliance if it is tipped up and do not turn
it over.
♦ Do not turn the appliance over while it is in use or
connected to the mains.
♦ Disconnect the appliance from the mains when not in
use and before undertaking any cleaning task.
♦ Store this appliance out of reach of children and/or
persons with physical, sensory or reduced mental or lack
of experience and knowledge.
♦ Make sure that dust, dirt or other foreign objects do not
block the fan grill on the appliance.
♦ Keep the appliance in good condition. Check that the
moving parts are not misaligned or jammed and make
sure there are no broken parts or anomalies that may
prevent the appliance from operating correctly.
♦ Never leave the appliance connected and unattended if
is not in use. This saves energy and prolongs the life of
the appliance.
Service:
♦ Any misuse or failure to follow the instructions for use
renders the guarantee and the manufacturer's liability
null and void.
DESCRIPTION
A Front grill
B Guard securing
C Front cover
D Spinner lock nut
E Propeller
F Guard lock nut
G Rear grill
H Motor shaft
I Shaft pin
J Oscillation control knob
K Handle
L Motor cover
M Foot base
N Upper stand tube *
O Lower stand tube *
P Stand tube
Q Speed button
(Original instructions)
R Screw *
S Base plate
(*) Only available on BXEFP60E
If the model of your appliance does not have the accesso-
ries described above, they can also be bought separately
from the Technical Assistance Service.
INSTALLATION
♦ Be sure to remove all packaging material from inside the
appliance.
♦ Ensure that the fan is switched off from the supply mains
before start any installation or assembly operation.
♦ The appliance should be used with its base fitted.
Assembling the base (ONLY FOR THE
DESK FAN):
♦ Put the power cord into the base hole and set the bulge
of stand tube alignment with space of base hole, and
turn the stand tube by clockwise direction.
ASSEMBLING THE BASE (ONLY FOR THE
STAND FAN):
♦ Insert the lower stand tube (O) into the base hole (S) and
keep the foot (M) of the stand tube alignment with space
of the base hole.
♦ Then use four screws (R) tighten (Fig.1).
♦ Insert the upper stand tube (N) into the lower stand tube
(O) by hand near the thread zone and turning it in a
clockwise direction (Fig.2).
Assembling the grill and the propeller:
♦ Remove the spinner lock nut and guard lock nut from the
motor shaft spindle.
♦ Fit the rear guard, by positioning on the location pins
♦ Secure the guard to the motor body with the guard lock
nut (Fig. 3).
♦ Push the fan blade onto the motor shaft by matching the
slots on the base of the blade with the shaft pin.
♦ Secure the blade with the spinner lock nut. The spinner
lock nut must be tightened by turning it in a coun-
ter-clockwise direction. Check that the fan blades rotate
freely by turning with your hand.
♦ Open the securing clip of the front guard.
♦ Fit together the rear guard with the front guard and press
the securing clip.
ENGLISH
5