Getting Ready; Charging; Taking Elvie Stride Apart - ELVIE stride Instrucciones De Uso

4. Getting ready

To get the most from your pump, it's really important to set
it up properly. This guide will show you how to assemble
your pump and how to customize it to fi t your body.

4.1 Charging

Plug in the Hub for fi ve minutes to wake it up before fi rst
use. The Hub will not turn on while it is charging. It takes
approximately two hours to fully charge the Hub,
although this can vary depending on your charging set up.
A full charge lasts approximately fi ve 30 minute sessions.
Only use the Charging Cable provided in the box.
Charge immediately after fi nishing your pumping session
if low battery is indicated.
Tip: Press the Mode button when the Hub is off ;
the Intensity Lights will show how much battery is left.
Tip: Close the Charging Port before use to ensure the
Hub is as discreet as possible.
10
Finger Grip
Battery low
Battery charging
Fully charged

4.2 Taking Elvie Stride apart

1. Remove the Cap. The Hub, Tubes and Cap must be
placed on a dry surface and kept away from water
2. Using the Finger Grips, pull the Cup Front away from
the Breast Shield
3. Pull the Valve out of the Breast Shield. Then remove
the Diaphragm
11