Cleaning; Before First Use - ELVIE stride Instrucciones De Uso

4.3 Cleaning

Before fi rst use
Elvie Stride is not provided sterile. It must be cleaned and
sanitized before fi rst use. Always disassemble the
components before cleaning or sanitizing. For additional
cleaning guidelines see the Center for Disease Control
website – https://www.cdc.gov/healthywater/hygiene/
healthychildcare/infantfeeding/breastpump.html
1. Before fi rst use, remove the Cup Seal by peeling it out
of the groove on the side. During normal cleaning this
Cup Seal can stay in place
2. To replace, stretch the Cup Seal over the outer rim of
the Cup Front. Make sure it goes on with the ridges
facing outwards. Press along the groove, checking
that it is snugly in place all the way around
Non-washable components
Charging Port Hub
Cover
Charging Cable
Hub Connector
Long Tube (for the Hub)
12
Cap Seal
Cap
Clip
Short Tube
(for the Cups)
Tube Splitter
Tube Splitter
Stopper
The Hub, Cap, Tubes, Tube Splitter, Cover and Clip are
non-washable components and should be kept dry.
They must not be microwaved. They can be wiped clean
with a damp cloth, but should not be submerged in water.
If the tubes are moldy, discard and replace immediately.
Washable components
Breast Shield
Diaphragm
Cup Seal
Valve
Cleaning washable components that come into contact
with milk, as soon as possible after pumping, prevents the
buildup of dry milk residue. Residue can cause the growth
of bacteria that may be harmful to you and your baby.
Cleaning (before fi rst use and after every use)
1. Rinse in cold, clear water. Do not place the parts
directly in the kitchen sink for rinsing and washing.
Use a dedicated wash basin and brush for infant feeding
2. Wash in warm water using mild dish washing soap
3. Rinse with cold, clear water for 10 to 15 seconds
OR
Place on the top shelf of the dishwasher
Stopper
Cup Front
13