Required Tools - MRA Tiger 1200 Explorer Manual Del Usuario

Read this manual carefully and check the parts list for completeness before you begin. We recommend that you have
Parts List:

1 x MRA screen
- 1 edge protection strip
- 2 clamp sleeves

Installation kit:
- 2 metal angles
- 2 rubber nuts
- 2 spacers, 15mm long
- 2 rubber washers, 4mm thick
- 4 screws, M 5 x 16
- 2 screws, M 5 x 35
- 4 plastic washers
1. Position the motorcycle on a level surface.
2. Remove the screws and the original windshield
(P1).
3. Fasten the metal angles with the screws M 5x16
on the upper fastening point in the position as
shown in P2.
4. Put the screws M 5 x 35 mm with the plastic washers in the lower holes of the windshield and position the 15 mm
long spacers and the 4 mm thick rubber washers from the inside.
5. Position the windshield and fasten its upper part with the screws M 5x16 with the plastic washers and its lower
part with the pre-installed long screws.
6. Where applicable: Pull the edge protection strip over the rear, exposed area of the screen, starting at the joint
with the cladding and moving to the opposite side. Cut off the excess as necessary.
7. Where applicable: Push the clamping ferrules over the ends of the edge protection strip and squeeze them lightly
with a pair of pliers so that the edge protection strip is clamped.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at regular intervals.
Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or spirits to clean the screen as
MRA-Klement GmbH + Siemens Str. 6 + D-79331 Teningen
Thank you for buying a MRA Windshield.
your screen fitted by an authorised workshop.
they will damage it.
I N S T A L L A T I O N M A N U A L
T i g e r 1 2 0 0 E x p l o r e r 2 0 1 2 -
Tel.: +49 7663 9389 0 + Email: info@mra.de

Required Tools:


Allen key 3mm

Allen key 5mm
P1
P2
© by MRA-Klement GmbH – 05/2012