Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CHARACTERISTICS
Cup Capacity
Voltage
Frequency
Motor Power
Power Rating
Rotation
Height
Width
Depth
Net Weight
Gross Weight
3. INSTALLATION AND PRE-OPERATION
3.1 Positioning
Your appliance must be positioned and leveled on a dry and
firm surface with 850 mm of height.
3.2 Electrical Installation
The power plug has 3 (three) pins, and the central one is
for the grounding. It´s mandatory that all three spots are
properly connected.
This appliance is not BIVOLT. After unpacking it, check the
voltage informed on the tag placed at the electrical cord.
3.4 Pre-operation
•
Check if the appliance is firm in its workplace.
•
Before using it, all the parts that are in contact with
the products to be processed should be washed with
water and mild detergent.
3.4.1 Cup Positioning
The Cup has a versatile tilting system which enables the Cup
to be tilted in a simple, quick and safe way.
To remove or to place the Cup #02 (Pic.01) just lift it using
the handle. Do always use the handle with a firm hold to
remove or to place the Cup.
Never move the Cup when the appliance is on.
3.4.2 Lid Positioning
The Lid was developed with non-toxic rubber and provides
efficient sealing during process. Check if the Lid is properly
positioned on the Cup edge. See picture below:
PICTURE 02
UNIT
TA4
l
4
V
110 or 220
Hz
50 / 60
W
1200
W
590
RPM
22.000
mm
700
mm
270
mm
240
Kg
5,3
Kg
6,4
3.4.3 Filler
Cap Positioning
The Filler Cap is used to follow the process and also to add
more product to be processed.
To remove the Upper lid, just turn in clockwise so that it
releases, pulling it up.
PICTURE 03
4. OPERATION
4.1 Starting the appliance
-
Connect the appliance to a power
-
To turn on the appliance, press ON Switch No. 01 (Picture
04).
-
To turn off the appliance, press OFF Switch No. 02 (Picture
04).
PICTURE 04
01
4.2 Operation Procedures
Remove the Lid with the Filler Cap.
First, fill the Cup with liquid products and after that, prod-
ucts with more consistency.
Do not use this blender to process dense products, like
the dessert known as "acai cream".
Cut the product in small pieces approximately 3.5 cm
wide, it will help to reduce the blending time particularly
with frozen products. When processing ice, it is obligatory
to add some water.
Place the Lid with the Filler Cap as described before in Items
3.4.2 and 3.4.3 and turn on the appliance.
The processing time changes for each product. Solid
products should not be processed without a liquid, because
overheating may occur and therefore damage the Cup seal.
Never turn on the Appliance when empty, because it
can cause irreparable damages.
outlet.
02
3
Publicidad
Tabla de contenido
