Remington i-LIGHT IPL5000 Manual Del Usuario página 4

IMPORTANT SAFETY INSTRUCTIONS
WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE,
OR INJURY TO PERSONS:
As with most electrical appliances, electrical parts are electrically live even when the
switch is off. To reduce the risk of injury or death by electric shock:
■ Always unplug the unit from the electrical outlet immediately after using.
■ Do not use near water.
■ Do not place or store this appliance where it can fall or be pulled into a tub or sink.
■ Do not place or drop into water or other liquid.
■ Do not reach for the unit if it has fallen into water or other liquid. Unplug unit
immediately.
■ Do not reach for the unit if it has become wet. Unplug unit immediately.
■ Unplug the unit before cleaning it.
■ Keep the unit dry at all times.
■ If you move the unit from a very cold to a very warm environment, wait approximately
2 hours before using it.
■ An appliance should never be left unattended when plugged into a power outlet.
■ Keep the power plug and cord away from heated surfaces.
■ Make sure the power plug and cord do not get wet.
■ Do not plug or unplug the unit with wet hands.
■ Do not use the product with a damaged cord. A replacement can be obtained via
®
the Remington Service Centre.
■ Use and store the product at a temperature between 15°C and 35°C.
■ Always unplug from the mains when cleaning.
■ Only use the parts supplied with the appliance.
■ Keep this product out of reach of children. The use of this appliance by persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge can give cause to hazards. Persons responsible for their safety should
give explicit instructions or supervise the use of the appliance.
8
100827_REM_IFU_IPL5000_21L GB8-GB9 100827_REM_IFU_IPL5000_21L GB8-GB9
i-Light Unit Diagram Reference
(page 3)
A i-Light Handpiece
B Flash Button
C Skin Contact Sensor
D Flash Window
E Nose Cone
F Nose Cone Release Buttons
G Light Cartridge
H Handpiece Cord
I i-Light Base Unit
J
Power Switch
Familiarize yourself with the features of your new i-Light device.
Flash Window (fig. 1-D)
The Flash Window is a filtered glass window with built-in UV protection that allows spe-
cific wavelengths of light to pass from the hand piece to your skin and hair follicles.
WARNING: Always inspect the Flash Window before use to ensure there is no
damage to the lens.
WARNING: Always clean the Flash Window before use with the lint-free cloth
provided to ensure there is no oil or debris on the lens.
(fig. 1-C)
Skin Contact Sensor
The Skin Contact Sensor is a safety mechanism that prevents the device from acciden-
tal activation. In order for the device to activate, the Skin Contact Sensor must be fully
depressed against the skin.
K Power Inlet
L Intensity Level Selection Button
M Intensity Level Selection Display
N Flash Mode Selection
O Flash Mode Selection Display
P Bulb Status Indicator Display
Q Power Cord
R Lint Free Cloth
05.11.10 13:25 05.11.10 13:25
9