Jøtul F 470 Serie Instrucciones Para Instalación página 10

ENGLISH
Fig. 9
7. Carefully remove the wooden pallet.
8. Place a packaging frame (Fig. 9 A) crosswise underneath
the base/pedestal/leg and cardboard packaging in front of/
beneath the product to prevent it from making marks on the
floor. Carefully raise the stove and stand it in its proper place
(Fig 1). Remember to position it straight above or behind the
external air supply, whichever is applicable.
9. Place the top plate (Fig. 3 A) temporarily in place and level the
fireplace. If the stove is not standing level, adjust the screws
shown in Fig. 8 A until the product is perfectly straight.
10. If an external air supply is not going to be connected, refit any
parts that have been removed from the product.
11. If installing a Jøtul F 471, F 475 or F 476 base, the shelf must
be secured as described in Chapter 4.7.
12. If the control handles (Fig. 3D) are difficult to pull out, see
step 4.6
10
Installation with external air supply
Fig. 10 - Base
Fig. 10 - Pedestal
Fig. 10 - Leg
1. Attach the hose to the external air connector using a hose
clip (Fig. 10 A Base and leg) (NB! Do not fit a hose clip onto
the Jøtul F 473 pedestal with a rotating set as this prevents the
set from rotating). NB! Make sure the hose is long enough so
that joints are not necessary. The external air hose insulation
ends approx. 10 cm below the burn chamber.
2. Refit any parts that have been removed from the product.