Hammerhead Lite Reflector Instructions - Hydrofarm PRO Serie Instrucciones

INSTRUCTION MANUAL

HAMMERHEAD LITE REFLECTOR INSTRUCTIONS

Thank you for purchasing the Hammerhead Lite Pro Series Reflector (part number PROHHL). These
instructions will help you assemble your reflector and have it hanging within minutes.
PARTS LIST
4 – M4 hex nuts
1 – Main support frame
30 – M4 wing nuts
38 – M4*8 screws
1 – Center reflector
2 – Side reflectors
1 – Socket kit
2 – End reflectors
2 – V-hooks for hanging
ASSEMBLING THE
REFLECTOR
1. Remove the reflector, hardware kit,
and any accompanying materials
from its packaging. Take care when
handling the reflector pieces to avoid
sharp edges.
2. Attach the socket kit tightly to the
main support frame with four of
the M4*8 screws, using a Philips
head screwdriver, in the positions as
indicated by the arrows in Figure 1.
Note that four of the screws come
pre-bolted into the assembly straight
out of the box (Figure 2). Make sure
the cord and hanging flange/folded
edge of the support frame are on the
same side. The ceramic mogul mount
should face in toward the center of
the support frame.
3. Flip the unit over so that the lamp
cord rests on the ground.
4. Peel away corners from each reflector
piece to access the screw holes. Leave
the rest of the film on the reflector
pieces to protect them from scratches
and fingerprints.
2
FIGURE 1
www.hydrofarm.com