SERVICE:
Only a qualified service person should repair gas
passages and associated components.
OPERATING ISSUE
Burner won't light.
Burner flame is low.
Thick black smoke
appears.
Carbon buildup.
PAGE 10 OF 31
CARE AND MAINTENANCE CONTINUED
TROUBLESHOOTING
CAUSES
1. Propane cylinder is frosted over.
2. Blockage in orifice.
3. Control knob is not in "ON" position.
1. Gas pressure is low.
2. Outdoor temperature is less than
40°F and tank is less than 1/4 full.
3. Control knob fully "ON."
4. Spiders and insects nest in burner
or orifices.
Blockage in burner.
Dirt or film on reflector and burner
screen.
1-800-295-5510
CAUTION! Always allow heater to cool before
attempting service.
1. Wait until the propane cylinder
warms up and becomes unfrosted.
2. Clear blockage.
3. Turn control knob to "ON."
1. Turn cylinder valve "OFF" and
replace cylinder.
2. Use a full cylinder.
3. Check burner and orifices for
blockage.
4. Clean burner and orifices.
Remove blockage and clean burner
inside and outside.
Clean reflector and burner screen.
uline.com
RECOMMENDATIONS
0821 IH-5839