Uline H-5839 Manual De Instrucciones página 5

5. Slide fastening nut
down the post with
the rounded side
facing down. Next,
slide the tightening
spacer down
the post with the
smaller side facing
down. Put the table
on the post with the
metallic side facing
up. (See Figure 5)
6. Insert the screw
coupler on the
post, inserting it
through the middle
of the table on
the post. Thread
the tightening
spacer on the
bottom of the table
counterclockwise
onto the screw
coupler. Tighten
securely to hold the
table to the screw
coupler. Thread the fastening nut counterclockwise.
Tighten securely to lock in place. Loosen the
fastening nut to adjust the position of the table on
the post. (See Figure 6)
7. Attach reflector
spacers and large
washers to the top
of head assembly.
Tighten the reflector
spacers.
(See Figure 7)
PAGE 5 OF 31
ASSEMBLY CONTINUED
Figure 5
Figure 6
Figure 7
8. Unscrew stainless
steel bolts from
head assembly.
(See Figure 8)
9. Insert hose of head
assembly into
post. Secure head
assembly to post
with stainless steel
bolts. (See Figure 9)
NOTE: The
control knob on
head assembly
should be
above the
decal on post.
10. Remove protective
cover from reflector
panel and reflector
plate.
(See Figure 10)
NOTE: In order
to achieve
proper
alignment
of reflector
sections, it may
be necessary
to loosen the
preassembled
bolts prior to assembly and retighten once
complete.
Figure 8
Figure 9
Figure 10
0821 IH-5839