HOW TO PREPARE A CAPPUCCINO / CLEANING INSTRUCTIONS
switch (4) again, and close the steam
knob (6) by turning it in a clockwise
direction.
Danger of burning! When water
begins to flow out, it may be very
hot. The steam tube does get very hot,
so avoid touching it in any way.
9
HOW TO PREPARE A CAP-
PUCCINO COFFEE USING
THE STEAM TUBE
• If the machine is not already on, turn it on
at the main switch (3) which will light up.
• Press the steam switch (5) which will light
up. The coffee switch „machine on" light
(4) will turn off.
• When the coffee switch „machine on"
light (4) comes back on , the steam tube
is ready to use.
•
Point the steam tube ("Pannarello")
over the drip tray and open the "hot
water/steam" knob (6) for a few seconds
to clear the tube of any excess water.
Wait for a few more seconds for steam to
flow out.
• Close the knob (6).
•
Immerse the tube in the liquid to be
heated and open the knob (6).
Move the container gently up and down
to ensure that the liquid is heated right
through.
• When the liquid has reached the required
temperature close the knob (6) and turn
off the "steam" switch (5).
To make a cappuccino heat milk
using the method explained
above.
Com004a 165925900 Rev01.pmd
• Proceed following the priming instructions
found in par. 4.5.
• When you have finished using the steam
tube clean with a damp cloth.
10 CLEANING INSTRUCTIONS
Before cleaning the machine, let it cool
down and unplug it.
• Do not immerse the coffee maker in water
and do not put any of the components in
a dishwasher.
• Do not use sharp objects or abrasive
chemical products (solvents) to clean the
machine.
•
fresh water daily.
• After heating milk, release a small quantity
of hot water to clean out the steam tube
and wipe the outside of it with a damp cloth.
•
appliance.
•
• Remove the filter, place it in hot water
and wash it carefully.
• Clean the inside of the filter holder.
• Do not dry the machine and/or any of its
parts using a microwave and/or
conventional oven.
• Clean the "Pannarello" located over the
steam tube, if it is fitted on your machine.
To do this, unscrew the ring nut, remove
the "Pannarello" from the steam tube and
take off the external casing.
Rinse the "Pannarello" under running
water and then put it back together again.
"Pannarello" may come loose during use.
29
Clean the water tank and fill it with
Use a damp cloth to wipe down the
Clean the filter holder as follows:
The ring nut must be closed
properly
as
otherwise
13/07/2003, 18.30
29
the