Ptz Control Panel; Main Menu - Z-BEN H.264 Manual Del Usuario

Pantalla gui controlada por el ratón
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 280
1~16
Video Channel Number
Sequence Display
Quad Display
9-Cut Display
16-Cut Display

3.2.2 PTZ Control Panel

Note: In the PTZ control mode, hot point is supported to move the camera view to the specified point
after a click.
Click
on the quick menu bar to display the panel as follows:
/
/
/
/
/
/

3.3 Main Menu

Right-click anywhere on the screen to show the main menu as follows, and right-click again to exit.
For details about each menu and its sub-menus, please refer to "5. MAIN MENU' at page 14.
For details about the menu structure, please refer to "APPENDIX 5 MAIN MENU STRUCTURE" at page 50.
Main Menu
Click to switch to the channel you want in full screen.
Click to display each channel in full screen one by one starting from CH1. When the last
channel is displayed, it will repeat from CH1 again.
When this function is on,
Press to show the 4-channel display mode.
Press to show the 9-channel display mode.
Press to show the 16-channel display mode.
Click to enter the camera main menu.
Camera Menu
For details about each camera menu, please refer to its own user manual.
Enter
Click to confirm your selection / enter the menu.
Up / Down / Left / Right
Click to move your selection up / down / left / right, or change settings.
Click to zoom in on the image to the largest / zoom out on the image to its
Zoom in / out max
original size.
Zoom in / out
Click to zoom in / out the image.
Focus near / far
Click to adjust the focus of the image.
Click to activate the auto function.
Auto mode
Before using it, you need to assign a specific function that will be enabled
when "AUTO" is clicked. For details, please refer to the user manual of the
PTZ camera.
Click to enter the PTZ preset point you want to see.
Preset point
QUICK START
DATE SETUP
SYSTEM
EVENT INFORMATION
ADVANCE CONFIG
SCHEDULE SETTING
GUI DISPLAY WITH USB MOUSE CONTROL
will be shown on the status bar.
Click to set the status display, image settings, and date &
time.
Click to set the date display and daylight saving.
Click to set the system configurations.
Click to enter the event search menu.
Click to set CAMERA, DETECTION, ALERT,
NETWORK, SNTP, DISPLAY, RECORD, REMOTE,
DCCS & IVS.
Click to set record timer and detection timer.
10

Publicidad

Tabla de contenido
loading

Tabla de contenido