Use E Reset; Accessories - Montarbo EARTH PRO Serie Manual De Uso

EARTH PRO

USE E RESET

6
WIND PRO EARTH PRO
The all new Montarbo ® and series is conceived and developed to facilitate the technician during the
connection and setting process, making the best use of all the product potential.
In addition to the analogue inputs on XLR connectors, these new loudspeakers feature two Ethercon inputs which, through
a single Cat 5E / 6 cable, allow the user to connect the system to the Dante protocol, for transmitting the audio signal, and
/ or connect to the Montarbo M-Connect and M-Modelling software for remote setting and controlling each individual
loudspeaker.
An integrated module also allows the loudspeaker - or loudspeaker system - to be connected via WiFi.
CONNECTION TO THE M-CONNECT SOFTWARE:
Make sure you have M-Connect software installed on
your Pc / MAC.
Create a network with 1GBit certified router
Use a CAT 5E / 6 Lan cable for connection between
the router and one of the two Ethercon ports on the
loudspeaker,
Turn on the loudspeaker.
Run the M-Connect software and start assigning the
desired parameters.
CONNECTION TO DANTE PROTOCOL:
Make sure you have Dante Controller software
installed on your Pc / MAC and use an audio mixer
with Dante card.
Create a network with 1GBit certified router,
Use a CAT 5E / 6 Lan cable for connection between
the router and one of the two Ethercon ports on the
loudspeaker,
Turn on the loudspeaker.
Run the Dante Controller software and start
assigning the desired parameters.
LOUDSPEAKER HARDWARE RESET:
1
turn off the loudspeaker
2 while holding down the PRESET button, turn on
the loudspeaker.
3
all LEDs will flash in 2 seconds after switching on
4 release the PRESET button then quickly press it again (1 click)
5
all LEDs will turn off
6 PRESET 1 LED will light on again
24
PUSH
TASTO
PRESET
PUSH PUSH

ACCESSORIES

7
DOLLY EARTH PRO 115-118
CONNECTION KIT FLY EP - WP
User manual
FLYBAR EARTH PRO 115-118
CONNECTION KIT FLY EP
25