Promise VTRAK M610p Guia De Inicio Rapido página 13

If there is no disk drive in the carrier, the Disk Status LED and the Power/Activity
LED will remain dark.
The Power/Activity LED flashes during drive activity.
The Disk Status LED displays Green when a drive is present and configured.
Step 7: Setting the IP Address
VTrak has a Command Line Interface (CLI) to manage all of its functions,
including customization. A subset of the CLI is the Command Line Utility (CLU), a
user-level interface that manages your VTrak via your PC's terminal emulation
program, such as Microsoft HyperTerminal. This procedure uses the serial cable
connection you made in Step 5 (see page 11).
You will use the CLU to assign an IP address to the VTrak to enable a network
connection for WebPAM PROe.
1. Change your terminal emulation program settings to match the following:
• Bits per second: 115200
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: none
2. Start your PC's terminal VT100 or ANSI emulation program.
3. Press Enter once to launch the CLI.
4. At the Login prompt, type administrator and press Enter.
5. At the Password prompt, type password and press Enter.
At this point, you are in the CLI. You can continue using the CLI to make
network settings or you can switch to the CLU.
• Setting up with the CLI (page 14)
• Setting up with the CLU (page 15)
Choosing DHCP or a Static IP Address
When you setup your VTrak, you have the option of:
• Enabling DHCP and letting your DHCP server assign the IP address to the
VTrak's virtual management port.
• Specifying a static IP address for the VTrak's management port.
If you choose to enable DHCP, have your Network Administrator dedicate an IP
address for the VTrak, linked to the VTrak's MAC address. This action will
Step 7: Setting the IP Address
13