Maintenance And Service; Maintenance And Cleaning; After-Sales Service And Application Service - Bosch LR 7 Professional Manual Original

OBJ_BUCH-2651-002.book Page 19 Thursday, August 25, 2016 11:33 AM
English | 19
Back lighting
The back lighting of the display is switched on at full strength when the measuring tool
is switched on. If no laser beam is detected and there is no operator input for 2 min-
utes, the back lighting is reduced by 50 %.
The back lighting can be switched off if you press the button for selecting the measur-
ing accuracy 2 and the audio signal button 4 simultaneously for at least 2 seconds.
Working Advice
Marking
When the laser beam runs through the center of the reception area 5, its height can
be marked at the centre mark 11 right and left on the measuring tool.
When marking, take care to align the measuring tool exactly vertical (for horizontal
laser beam), or horizontal (for vertical laser beam), as otherwise the marks are offset
with respect to the laser beam.
Attaching with the Magnet (see figure B)
When a positive-lock attachment is not absolutely required, the measuring tool can be
attached to steel parts via the the magnets 7.

Maintenance and Service

Maintenance and Cleaning

Keep the measuring tool clean at all times.
Do not immerse the measuring tool in water or other fluids.
Wipe off debris using a moist and soft cloth. Do not use any cleaning agents or solvents.

After-sales Service and Application Service

Our after-sales service responds to your questions concerning maintenance and
repair of your product as well as spare parts. Exploded views and information on
spare parts can also be found under:
www.bosch-pt.com
Bosch's application service team will gladly answer questions concerning our
products and their accessories.
In all correspondence and spare parts orders, please always include the 10-digit
article number given on the nameplate of the product.
Bosch Power Tools 1 609 92A 3G1 | (25.8.16)