Umbrosa Spectra Manual De Instrucciones página 3

wren info㸀ar
Structured powder The impact of sharp objects can
coating on : damage the coating. Scratches
- Stainless steel 316 or dents can be touched up with
- Galvanised steel paint pens. However this only
camouflages the scratches with-
out removing them.
Anodized aluminum Anodization is the best protection
against corrosion. Red rust is
impossible on anodized alumi-
num. The anodization layer is also
self-healing. In case of scratches
the anodization skin will close
itself.
Galvanised steel Galvanisation is the most durable
method for protecting metal from
rusting. The metal is immersed
in a zinc bath which results in a
protective layer. If the layer gets
damaged, the metal under it will
start rusting. However, any dam-
age can be touched up with zinc
paint available at any DIY store.
Galvanised steel has a very long
life span and is recyclable.
Inside of the pole
Inside moving parts
MATERIALS AND MAINTENANCE GUIDE
info㸀ar
Winter stock check and Brush off encrusted dirt. Then use a soft cloth, mild detergent and water to
spring check remove the stains. Wipe dry with a soft cloth. Never use an abrasive sponge or
cleaner because this will damage the coating layer and leave matt spots that
will not disappear.
Winter stock check and Only do this when there are scratches. Order a special paint pen. Brush off
spring check encrusted dirt. Then use a soft cloth, mild detergent and water to remove the
stains. Wipe dry. Tip with the brush with the correct colour. Only apply on the
scratch itself, very locally. Let dry out well. When not sure about the correct
colour, first try on an invisible spot.
Winter stock check and Brush off encrusted dirt. Then use a soft cloth, mild detergent and water to
spring check remove the stains. Wipe dry with a soft cloth. Never use an abrasive sponge or
cleaner because this will damage the anodization layer and leave spots that
will never disappear.
Winter stock check and Brush off encrusted dirt. Then use a soft cloth, mild detergent and water to
spring check remove the stains. Wipe dry with a soft cloth.
Every 1-3 months Remove all loose dirt from the inside of the pole with a soft brush. Then clean
with tap water, mild soap and a soft cloth. Dry with a soft cloth.
DO NOT use any lubricant on any parts except when explicitely noted in the
manual.
Beversesteenweg 565 B - 8800 Roeselare - Belgium - T: +32 51 30 22 60 - info@umbrosa.com
ques