Buffalo HD-QLU3R5 Manual De Usuario página 32

5
Hold down the RAID mode button for five seconds.
The DriveStation will beep once, the access LED turns off, and the power LED will blink purple as
the DriveStation changes its RAID mode.
Caution While the power LED is blinking purple, do not turn off the power or unplug your
DriveStation. It could be damaged if power is lost during the RAID change.
6
When the change is complete, the DriveStation will beep three times and the
power LED will stop blinking.
7
The access LEDs now show the new RAID mode.
8
Press the RAID mode button.
The DriveStation will beep and shut down.
The RAID mode is now changed. Your new RAID array is not formatted yet, so connect the drive to
your computer and format it.
Checking the RAID Mode
1
Disconnect the DriveStation from the computer.
2
Move the power switch to the OFF position, then set it to AUTO.
Wait for the power and access LEDs to turn off.
3
Press the RAID mode button on the back side.
The DriveStation will beep.
4
The power LED will turn purple and the current RAID mode is indicated by the
access LEDs.
The current RAID mode is indicated by the colors of the access LEDs as shown below. If the
DriveStation is in Windows XP compatibility mode, the access LEDs will blink.
RAID Mode
Normal Mode
RAID 0
RAID 1
RAID 5
RAID 10
Spanning
A table of LED colors for each RAID mode is also available on the back side of the front
cover.
After confirmation is complete, press the RAID mode button.
The DriveStation will beep and shut down.
Disk 1 Disk 2
Green Red
Red Red
Green Green
Green Green
Green Green
Orange Orange
Disk 3 Disk 4
Green Red
Red Red
Green Green
Green Orange
Orange Orange
Orange Orange
HD-QLU3 User Manual
31