STAR Water Systems SPCP02 Guia De Inicio Rapido

UTILITY POOL
COVER PUMP
MODEL #SPCP02
CONTENTS
Pump
Base
Garden Hose Adaptor
Cap
QUICK START GUIDE. SEE INSTRUCTION
MANUAL FOR COMPLETE DETAILS.
WARNING:
FOR YOUR PROTECTION, ALWAYS
DISCONNECT PUMP FROM POWER
SOURCE BEFORE HANDLING.
1. Install the snap-on
strainer by lining up
the pump base to
match the strainer.
Push down gently
until it latches.
2. Attach garden hose
adapter to the top pump
discharge. DO NOT
OVER-TIGHTEN THE
HOSE ADAPTER. Finger
tight plus 1/4 to 1/2 turn
should be sufficient.
Ensure cap is installed
on top discharge.
Toll Free Help Line: 1-800-742-5044, 7:30 a.m. - 5:00 p.m., EST, Monday - Friday.
3. If using garden hose
QUANTITY
1
4. Place pump in an
1
1
1
5. Plug the pump into a properly
For best performance, use discharge hose of
50 ft. or less. If the discharge runs up hill, or is
extra long, use larger diameter discharge hose
or rigid pipe.
NOTE: Large diameter, short discharge hoses
or pipe will provide better water flow rates than
small diameter, long discharge hoses or pipe.
(not included), thread
the female end of
the garden hose into
the male end of the
garden hose adapter.
For best performance,
unwind the hose
before starting the
pump.
upright position on
the pool cover where
water will collect. Do
not suspend pump by
the discharge hose or
power cord.
Be sure pump is not
sitting in mud, sand, or
debris.
grounded, ground fault circuit
interruptor (GFCI) 115 V
outlet. For safety, the pump
should always be electrically
grounded to a suitable
electrical ground, such as
a grounded water pipe,
properly grounded metallic
raceway, or ground wire
system.
SW1695 A