Switching On/Off - Boneco U7144 Manual De Instrucciones

Operation U7144
en
L
I
K
D
A
E
A) Switching on/off
You can switch the unit on or off by pressing button A. This
button is also used to reset the cleaning indicator light (by
holding down).
B) Hygrostat (pre-set moisture level)
By pressing button B you can set the desired moisture level
in %. A relative moisture of between 40 and 60% is recom-
mended. The accuracy of measurement is +/- 5%. The unit
will switch off when the moisture level exceeds the desired
setting. During selection the target value is displayed. The
display will automatically show the current value after a
few seconds.
18
C) Timer
Using button C, the operation time can be set - adjust-
able between 1 and 8 hours, or continuous operation.
Letter G shows the operating period that has been set
H
(1h/2h/3h/4h/5h/6h/7h/8h). The display will automatically
show the current value after a few seconds.
D) Controlling mist output and Evaporator
G
output
By repeatedly pressing button D you can control the mist
J
output. The LO/ME/HI display (H) shows which of the three
levels (low/medium/high) you have selected.
M
E) Operation with pre-heating
Button E is used for switching the pre-heating on and off
(letter I lights up). As a result, the water is pre-heated to a
temperature of 80 °C before entering the nebuliser space.
F
It takes approx. 10 to 15 minutes for the water in the base
to warm up. The mist now leaves the nebuliser space at
B a pleasant temperature of 40 °C. The advantage of this
is that the room temperature does not drop and, in addi-
tion, it significantly improves the water quality maintenance
C
(bacteria are killed).
F) Auto/Sleep
The automatic and sleep modes can be activated by press-
ing button F. By pressing the button once, the automatic
function is switched on (letter J appears on the display),
maintaining the optimum humidity subject to the tempera-
ture. Control takes place by means of output quantity and
pre-set target value. If the sleep function is switched on
(the letter K appears on the display), the target humidity is
60%; the operation time is automatically set at 6 hours; the
heating is switched on. In addition, the output quantity is
also controlled subject to the difference between the target
value and the actual value.
The Timer cannot be changed in either mode. If other but-
tons are pressed, the unit will no longer be in auto or sleep
mode.
L) Empty indicator
The transparent water tank makes it possible to see the
water level well. Furthermore, the unit shows on the display
(L) when water should be added.
Please read the chapter "Filling the tank" for more informa-
tion. The symbol L may stay illuminated for some seconds
with a refilled tank until the base is filled with water.
M) Cleaning indicator
If symbol M and "CLEAN" appear on the display, the appli-
ance should be cleaned as recommended by the manufac-
turer. This symbol comes on automatically every 2 weeks,
depending on the level of use. The display can be cancelled
by depressing button A for between 10 and 15 seconds.